Bavarian A II
Bavarian A II | |
---|---|
Number(s) | Names and inventory nos. |
Quantity | 13 |
Manufacturer | Kessler, Maffei |
Year(s) of manufacture | 1847ff. |
Retired | by 1877 (some were converted) |
Wheel arrangement | 2-2-2 |
Axle arrangement | 1A1 n2 |
Gauge | 1,435 mm (4 ft 8 1⁄2 in) |
Length over buffers | 12,496 mm (492.0 in) |
Service weight | 21.8 t (21.5 long tons; 24.0 short tons) |
Adhesive weight | 7.6 t (7.5 long tons; 8.4 short tons) |
Axle load | 7.6 t (7.5 long tons; 8.4 short tons) |
Top speed | 45 km/h (28 mph) |
Driving wheel diameter | 1,524 mm (60.0 in) |
Leading wheel diameter | 915 mm (36.0 in) |
Trailing wheel diameter | 915 mm (36.0 in) |
No. of cylinders | 2 |
Cylinder bore | 318 mm (12.5 in) |
Piston stroke | 559 mm (22.0 in) |
Boiler Overpressure | 6 bar (600 kPa) |
Grate area | 0.83 m2 (8.9 sq ft) |
Evaporative heating area | 71.00 m2 (764.2 sq ft) |
Tender | 2 T 4,2 |
Water capacity | 4.2 m3 (150 cu ft) |
The Bavarian A II engines were early German 2-2-2 steam locomotives with the Royal Bavarian State Railways (Königlich Bayerische Staatsbahn).
The locomotives were conceived as Stephenson Long Boiler engines. They had an inside forked frame and the firebox was supported by the trailing axle. The only difference between the engines from the two manufacturers was the location of the feed pump. On the Kessler variant this was on the outside and driven by crank pins; on the Maffei version they were suspended from the reverse eccentric cam (Rückwärtsexzenter).
After it was discovered that the riding qualities of the loco were very rough, the trailing axle was moved about 127 mm (5.0 in) further back. In the 1860s the old boiler on some vehicles was replaced by a Crampton boiler. In addition, six engines were rebuilt with a wheel arrangement of 0-6-0 and three into 0-4-2 locomotives. The remainder were taken out of service between 1871 and 1877 and scrapped.
They were coupled with 2 T 4.2 tenders.