Loewe 3NF

The Loewe 3NF was an early attempt to combine several functions in one electronic device.[1]

Produced by the German Loewe-Audion GmbH as far back as 1926, the device consisted of 3 triode valves (tubes) in a single glass envelope together with two fixed capacitors and four fixed resistors required to make a complete radio receiver. The resistors and capacitors had to be sealed in their own glass tubes to prevent them from contaminating the vacuum.

The only other parts required to build a Radio receiver were the tuning coil; the tuning capacitor and the loudspeaker. The device was produced not to enter the Integrated circuit era several decades early, but to evade German taxes levied on a per valveholder basis. As the Loewe set had only one valveholder, it was able to substantially undercut the competition. The resultant radio receiver required a 90 volt HT plus a 4 volt LT (A and B) battery (the HT battery provided not only 82.5 volts for the HT but also two grid bias supplies at -1.5 volts and -7.5 volts).

One major disadvantage of the 3NF was that if one filament failed, the whole device was rendered useless. Loewe countered this by offering a filament repair service.

Loewe were to also offer the 2NF (two tetrodes plus passive components) and the WG38 (two pentodes, a triode and the passive components).

Wikimedia Commons has media related to 3NF.

References


This article is issued from Wikipedia - version of the 1/31/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.