The Iron Bridge

The Iron Bridge
The Iron Bridge
Coordinates	52°37′38″N 2°29′08″W / 52.627245°N 2.485533°W / 52.627245; -2.485533 (The Iron Bridge)Coordinates: 52°37′38″N 2°29′08″W / 52.627245°N 2.485533°W / 52.627245; -2.485533 (The Iron Bridge)
Carries	Pedestrian traffic
Crosses	River Severn
Locale	Ironbridge Gorge near Coalbrookdale
Heritage status	Grade I listed
Characteristics
Design	cast iron arch bridge
Longest span	100 feet 6 inches (30.63 m)
History
Construction begin	November 1777
Construction end	January 1781
Opened	1 January 1781

The Iron Bridge is a bridge that crosses the River Severn in Shropshire, England. Opened in 1781, it was the first arch bridge in the world to be made of cast iron, and was greatly celebrated after construction owing to its use of the new material.

In 1934 it was designated a Scheduled Ancient Monument and closed to vehicular traffic. Tolls for pedestrians were collected until 1950, when ownership of the bridge was transferred to Shropshire County Council. It now belongs to Telford and Wrekin Borough Council. The bridge, the adjacent settlement of Ironbridge and the Ironbridge Gorge form the UNESCO Ironbridge Gorge World Heritage Site. The bridge is a Grade I listed building, and a waypoint on the South Telford Heritage Trail.

History

Background

The Iron Bridge from above

Abraham Darby I first smelted local iron ore with coke made from Coalbrookdale coal in 1709, and in the coming decades Shropshire became a centre for industry due to the low price of fuel from local mines.^[1] The River Severn was used as a key trading route, but it was also a barrier to travel around the Severn Gorge, especially between the then important industrial parishes of Broseley and Madeley,^[2] the nearest bridge being at Buildwas two miles away.^[3][4] The use of the river by boat traffic and the steep sides of the gorge meant that any bridge should ideally be of a single span, and sufficiently high to allow tall ships to pass underneath.^[4][5] The steepness and instability of the banks was problematic for building a bridge, and there was no point where roads on opposite sides of the river converged.^[6]

The Iron Bridge was the first of its kind to be constructed, although not the first to be considered or the first iron bridge of any kind. An iron bridge was partly constructed at Lyons in 1755, but was abandoned for reasons of cost,^[7] and a 22.2 metres (73 ft) span wrought iron footbridge over an ornamental waterway was erected in Yorkshire in 1769.^[8]

Proposal

In 1773, architect Thomas Farnolls Pritchard wrote to his 'iron mad' friend and local ironmaster, John Wilkinson of Broseley, to suggest building a bridge out of cast iron.^[9] Pritchard had previous experience with the design of both wooden and stone bridges, and it is possible that he had integrated into these designs elements of iron.^[10]

During the winter of 1773–74, local newspapers advertised a proposal to petition Parliament for leave to construct an iron bridge with a single 120 feet (37 m) span.^[11] In 1775, a subscription of between three and four thousand pounds was raised, and Abraham Darby III, the grandson of Abraham Darby I and an ironmaster working at Coalbrookdale, was appointed treasurer to the project.^[11]

In March 1776, the Act to build a bridge received Royal Assent. It had been drafted by Thomas Addenbrooke, secretary of the trustees, and John Harries a London barrister^{[lower-roman 1]} then presented to the Commons by Charles Baldwyn, MP for Salop.^[12] Abraham Darby III was commissioned to cast and build the bridge.^[4][13] In May 1776, the trustees withdrew Darby's commission, and instead advertised for plans for a single arch bridge to be built in "stone, brick or timber."^[14] No satisfactory proposal was made, and the trustees agreed to go with Pritchard's design, but there was continued uncertainty about the use of iron, and conditions were set on the cost and duration of the construction.^[14] In July 1777 the span of the bridge was decreased to 90 feet (27 m), and then increased again to 100 feet 6 inches (30.63 m), possibly in order to accommodate a towpath.^{[15][lower-roman 2]}

Construction

Pedestrians crossing the Iron Bridge with Ironbridge in the background

The site, adjacent to where a ferry had run between Madeley and Benthall, was chosen for its high approaches on each side and the relative solidity of the ground.^[4] The Act of Parliament described how the bridge was to be built from a point in Benthall parish near the house of Samuel Barnett to a point on the opposite shore near the house of Thomas Crumpton.^[16] Pritchard died on 21 December 1777 in his tower-house at Eyton on Severn, only a month after work had begun, having been ill for over a year.^[4][9][17]

The masonry and abutments were constructed between 1777 and 1778, and the ribs were lifted into place in the summer of 1779.^[18][19] The nascent bridge first spanned the river on 2 July 1779, and it was opened to traffic on 1 January 1781.^[20][21]

More information about how the bridge was built came from the discovery in 1997 of a small watercolour by Elias Martin in a Stockholm museum, showing the bridge under construction in 1779.^[20] A half-size replica of the main section of the bridge was built in 2001 as part of the research for the BBC Timewatch programme which was shown in 2002.^[20][22]

Design

The bridge is built from five cast iron ribs that give a span of 30.6 metres (100 ft).^[19] Exactly 378 long tons 10 cwt (847,800 lb or 384.6 t) of iron was used in the construction of the bridge, and there are almost 1700 individual components, the heaviest weighing 5.5 long tons (5.6 t).^[19][23] Components were cast individually to fit with each other, rather than being of standard sizes, with discrepancies of up to several centimeters between 'identical' components in different locations.^[24]

Decorative rings and ogees between the structural ribs of the bridge suggest that the final design was of Pritchard, as the same elements appear in a gazebo he rebuilt.^[18][25] A foreman at the foundry, Thomas Gregory, drew the detailed designs for the members, resulting in the use of carpentry jointing details such as mortise and tenon joints and dovetails.^[4][19][26]

Two supplemental arches, of similar cast iron construction, carry a towpath on the south bank and also act as flood arches. A stone arch carries a small path on the north, town, bank.

Cost

Darby had agreed to construct the bridge with a budget of GB£3,250 and GB£3,250 was raised by subscribers to the project, mostly from Broseley. Whilst the actual cost of the bridge is unknown, contemporary records suggest it was as high as GB£6,000, the excess being born by Darby, who was highly indebted from other ventures as well.^[27] However, by the mid-1790s the bridge was highly profitable, and tolls were giving the shareholders an annual dividend of 8 per cent.^[28]

Later history

Crack and repairs in bridge

Cracked supports

The opening of the bridge resulted in changes in the pattern of settlement in the Gorge, and roads around the bridge were improved in the years after its construction.^[29] The town of Ironbridge, taking its name from the bridge, developed at the northern end.^[29] The trustees, as well as local hotel keepers and coach operators, promoted interest in the bridge among members of polite society.^[29]

Repairs

In July 1783, a 35-yard (32 m) wall was built in order to prevent the north bank from slipping into the river.^[30] Cracks were found in the stone land arch on the south side in December 1784, and the neighbouring abutment showed signs of movement.^[19] The Gorge is very prone to landslides, and over 20 are recorded in the British Geological Survey's National Landslide Database in the area.^[31] It was suspected that the sides of the gorge were moving towards the river, forcing the feet of the arch towards each other, and consequently repairs were carried out in 1784, 1791 and 1792.^[19][30]

It was the only bridge on the River Severn to survive the flood of February 1795 undamaged, due to its strength and small profile against the floodwaters.^[32] The medieval bridge at Buildwas was replaced with a cast iron bridge by Thomas Telford, which, by virtue of superior design, required half the quantity of iron despite a longer span of 39 metres (128 ft).^[33][34] The Buildwas bridge survived until 1906.^[33]

In 1800 the trustees commissioned repairs which lasted for several years, and involved the replacement of the stone land arches with wooden ones to relieve pressure on the main span.^[19][30] A proposal to build a rigid support between the abutments to keep them part was found to be impossible with the available technology, but was achieved during the later restoration of the bridge in the 1970s.^[35] In 1812, its construction was described as "very bad" by Charles Hutton, and he predicted that it would not last for long, "though not from any deficiency in the iron-work."^[36] The timber arches were replaced with cast iron ones in December 1820, and further repairs were necessary throughout the remainder of the 19th century.^[19][37]

On 24 August 1902, a 30 feet (9.1 m) length of parapet collapsed into the river, and a section of deck plate weighing around 5 cwt fell from the bridge in July 1903.^[37] The opening of a toll-free concrete bridge in 1909 caused concern among the trustees, but it continued to be used by vehicles and pedestrians.^[38][39]

Closure

Table of tolls

A 1923 report by Mott, Hay and Anderson suggested that other than the paintwork, the main span of the bridge was in good condition. It was suggested that the metal deck of the bridge was dangerously heavy, and that after removing the dead weight the bridge should be reopened to vehicles no heavier than 2 tonnes (2.0 long tons; 2.2 short tons) and restricted to the centre of the roadway.^[40] A weight limit of 4 tonnes (3.9 long tons; 4.4 short tons) was imposed, but the housing boom of the 1930s meant that drivers distributing tiles produced at Jackfield were insistent that they should be allowed to use the bridge, so the trustees took the decision to close the bridge to vehicular traffic with effect from 18 June 1934.^[40] That same year, it was designated a Scheduled Ancient Monument.^[19] Tolls for pedestrians were collected until 1950, when ownership of the bridge was transferred to Shropshire County Council.^[41] The tolls collected only marginally covered the cost of collection, leaving no money for conservation, and the bridge had not been cleaned or painted for many years.^[40] In 1956 the County Council made a proposal to demolish the bridge and replace it with a new one, but this plan did not come to fruition.^[5]

Restoration

The brick tollhouse at one end of the bridge

After negotiations to raise the required funds, a programme of repairs took place on the foundations of the bridge at a cost of GB£147,000 between 1972 and 1975.^[42] The consulting engineers Sandford, Fawcett, Wilton and Bell elected to place ferro-concrete inverted arch under the river to counter inward movement of the bridge abutments.^[19][43] Construction of the arch was carried out by the Tarmac Construction Company starting in the spring of 1973, but unusually high summer floods washed over the cofferdam, frustrating hopes that the work could be done in a single summer.^[44] Filling material was removed from the south abutment to reduce its weight, and the arch through it was reinforced with concrete.^[45] The road surface was replaced with a lighter macadam, the stone of the abutments was renewed and the toll-house was restored as an information centre.^[46] In 1980, the structure was painted for the first time in the 20th century, and the work was complete for the bicentenary of the opening, which was celebrated with a pig roast on 1 January 1981.^[47]

In 1999–2000, the bridge was scaffolded to allow examination by English Heritage. The bridge was also repainted and minor repairs carried out.^[48]

Artistic depictions

The painting of the bridge by William Williams

Over fifty painters and engravers came to the area around Coalbrookdale during the period 1750–1830 to witness and record the rise of industry.^[18] Possibly the first artist to depict the bridge was William Williams, who was paid 10 guineas in October 1780 by Darby for a "drawing" of the bridge.^[49] An engraving by Michael Angelo Rooker proved popular, and a copy was purchased by Thomas Jefferson.^[50]

In 1979, the Royal Academy held an exhibition entitled "A View from the Iron Bridge" to commemorate the bicentenary of the bridge.^[51]

See also

• Coalport
• Crossings of the River Severn
• Ironbridge Gorge Museums
• The Iron Bridge, Rio Cobre, Jamaica

Notes

References

Citations

Sources

• Briggs, Asa (1979). Iron Bridge to Crystal Palace: Impact and Images of the Industrial Revolution. Thames and Hudson in collaboration with the Ironbridge Gorge Museum Trust. ISBN 978-0-500-01222-2. 
• Charlton, T. M. (2002). A History of the Theory of Structures in the Nineteenth Century. Cambridge University Press. ISBN 978-0-521-52482-7. 
• Cossons, Neil; Trinder, Barrie Stuart (2002) [1979]. The Iron Bridge: symbol of the Industrial Revolution. Phillimore. ISBN 978-1-86077-230-6. 
• Hutton, Charles (2013) [1812]. Tracts on Mathematical and Philosophical Subjects, Comprising Among Numerous Important Articles, the Theory of Bridges, With Several Plans of Recent Improvement. 1. Forgotten Books. 
• Lay, M. G. (1992). Ways of the World: A History of the World's Roads and of the Vehicles That Used Them. Rutgers University Press. ISBN 978-0-8135-2691-1. 
• Petroski, Henry (1996). Invention by Design: How Engineers Get from Thought to Thing. Harvard University Press. ISBN 978-0-674-46368-4. 
• Powell, John (2013). Ironbridge Gorge Through Time. Amberley Publishing. ISBN 978-1-4456-2896-7. 
• Smith, Stuart (1979). A View from the Iron Bridge. Ironbridge Gorge Museum Trust. ISBN 0-903971-09-7. 
• Tilly, Graham (2002). Conservation of Bridges. CRC Press. ISBN 978-0-419-25910-7. 

External links

Wikimedia Commons has media related to The Iron Bridge.

• Iron Bridge & Tollhouse – Ironbridge Gorge Museums Trust
• Virtual tour, from the BBC (VRML plugin required, then use PgUp/PgDn to move between viewpoints)
• River Severn Bridges
• A geological assessment of the landslides in the Ironbridge Gorge, Shropshire (Report)
• The Iron Bridge at Structurae